Car will not turn over, no power to starter cylinoid
Asked by Wayne Mar 07, 2021 at 04:13 PM about the 2004 Chevrolet Impala
Question type: Maintenance & Repair
I had starter tested, good battery, new dash cluster,
it won’t crank over, no power to obd port, and the
gear selector ( prnd123) shows nothing selected .
I’ve checked relays and fuses too!!! I looked for a
neutral safety switch but did not see one on my
trans, only the linkage and cable
3 Answers
for datalink connector. Pin 16 is hot all the and fuse protected. Use a test light to check. If no voltage at pin 16, check the fuse in diagram. Check voltage at the fuse.
Just to show where pin 16 is located. note the picture.
Make sure battery has a full charge and connections all good. Terminal B in diagram, at starter, is hot all the time, comes from battery. The S terminal, in the diagram, at starter, goes hot when crank relay is energized. Any testing at starter motor, make sure transmission is in park or neutral and parking brake is set. vehicle can't move. can you read wiring diagram, below?