Parts for re-installing a 4spd to a 1970 GTO that currently has an automatic

Asked by KonaBoy Oct 15, 2012 at 03:19 PM about the 1970 Pontiac GTO

Question type: General

Is there a complete parts list to make this conversion?  Driveshaft lenngth, is there a standard length?  Will be installing an M-20 with street clutch assembly.  Rearend is a ten bolt, do not know what rear ratio is.
Engine is a 400 with ram air.

1 Answer

5,135

you'll need bell housing & bearing fork , shifter kit , tranny mount , cross member, Z bar & linkage to pedal , 4 speed pedal set, return springs, the bracket for the Z bar ( mounts to the frame) ball fitting for Z bar ( mounts on engine side) .you might get away with the drive shaft , if anything it will be too short . if you are using headers check for clearence where Z bar mounts. i recently did my 65 lemans from auto to 4 speed . all the parts are available used .

Your Answer:

CarGurus Experts

  • #1
    Rucko
    Reputation
    880
  • #2
    taver91
    Reputation
    820
  • #3
    Norm Davis
    Reputation
    800
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chevrolet Corvette
29 Great Deals out of 1,060 listings starting at $15,871
Used Ford Mustang
65 Great Deals out of 1,259 listings starting at $4,995
Used Pontiac Firebird
15 listings
Used Chevrolet Camaro
16 Great Deals out of 307 listings starting at $10,500
Used Dodge Charger
38 Great Deals out of 645 listings starting at $4,888
Used Dodge Challenger
33 Great Deals out of 475 listings starting at $7,999
Used Chrysler 300
34 Great Deals out of 516 listings starting at $4,999

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.