sounds like hub bearings are bad,may have to change both hubs but not expensive or a hard job to do still i would take to your mechanic to check.
littlehorn answered 16 years ago
Is it in the steering column itself? I have heard of problems where the plastic swells a bit and causes squeaking. You may need to replace the column to get rid of it.
Loud noise when turning wheel, Loud noise upon take off
2000 Chevrolet Blazer
-
Maintenance & Repair
I have 1989 chevy blazer 4x4 the problem is that when I put my turn signal on both rear light flash.
1989 Chevrolet Blazer 2-Door 4WD
-
Maintenance & Repair
When I am driving my 2000 Blazer ZR2 the front wheels will turn slightly by themselves when going around a turn. It like floats a little bit and it scared the crap out of me at 55 mph. What would ca...
2000 Chevrolet Blazer LS 2-Door 4WD
-
Maintenance & Repair
My son bought a 2000 blazer 4x4 It was stalling out on him. This is what we have done so far New Fuel pump, omc unit , changed the box that hold all the censers as he was having issues with censer...
2000 Chevrolet Blazer LS 2-Door RWD
-
Maintenance & Repair
When I turn at low speeds, such as when parking, my 2000 Chevy Blazer shakes violently until the wheel is straight and im parked. I dont lock the wheel when i turn ir, not sure of the person who o...
2000 Chevrolet Blazer LS 4-Door 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.