how can i reset the meesage board low coolant message?
1 Answer
littlehorn answered 17 years ago
If it is continuously on and you've checked the coolant, it's likely your coolant level sensor is shot.
1 people found this helpful.
littlehorn answered 17 years ago
If it is continuously on and you've checked the coolant, it's likely your coolant level sensor is shot.
2000 Chevrolet Impala
-
Maintenance & Repair
Check Engine light keeps coming on, code states gas cap, replaced gas cap but twenty minutes after it was reset at the garage it came on again, code states same issue. How can I reset the Check Engi...
2008 Chevrolet Impala
-
Maintenance & Repair
How do reset the low tire light gauage? I have tried the turning on the interior light 3 times with the ignition switch on the on position. This hasn't work. There is suppose to be another way does...
2004 Chevrolet Impala
-
Maintenance & Repair
I lost both sets of key to my impala. One at work, the other in the snow at home. I am concerned someone will find them n get into my car. i had a new key cut. what i'd like to know is can i delete ...
2009 Chevrolet Impala 1LT FWD
-
Maintenance & Repair
I have had all of my tires checked and they all have the appropriate amount of pressure in them but I can't make the low tire pressure alert light go off.
2004 Chevrolet Impala LS FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.