Position crankshaft sensor

Asked by Tiffani Feb 28, 2019 at 11:01 AM about the 1998 Chevrolet Lumina

Question type: Maintenance & Repair

Where is it located

27,570

oilyspill answered 5 years ago

The 7x sensor is probably, looking under the hood, on backside of engine, down low. You might get at it from underneath.

Mark helpful

Your Answer:

Position crankshaft sensor 1 Answer

Where is it located

1998 Chevrolet Lumina

-

Maintenance & Repair
Replacing throttle position sensor on a 1992 z34 5 speed 1 Answer

How to replace throttle position sensor it started next time I tried wouldn't fire tried 2 times over the next few months and then it finally started and now it won't again

1992 Chevrolet Lumina Z34 Coupe FWD

-

Maintenance & Repair
Where is the thermostat temperature gauge sensor 1 Answer

My car is telling me that is running hot but it's not so I was trying to figure out where is the sensor at for that is saying is 260 degrees but it's not

1998 Chevrolet Lumina LS Sedan FWD

-

Maintenance & Repair
My 1999 Chevrolet Lumina had a mass air flow sensor problem. It kept stalling out. I drove it out of state, then once i got back, now it wont crank up! A friend said the mass air flow sensor would 2 Answers

A friend said the mass ait fow sensor would not cause the car not to start.. do you think its a solenoid sensor or possibly the starter ??

1999 Chevrolet Lumina LTZ Sedan FWD

-

Maintenance & Repair
Chevy Lumina 91 3.1 4dr...multi...I got a codes, 14 and 42...14 is heat temp high...and 42 is a ESC or EST Eletric Spark Timing, now I went and got a paper clip to pull these codes...it works. 12,12,12, and 14,14,14 and then 4..2 so it is 42...42 is behind the coil pack and then also it is connected to the crank sensor...What ever it is...I did check spark on the to top right side coil pack and the spark is powerful...removing 2 plug wires to test spark...so under that, change that and then the crank sensor...and the the Heat sensor for the water or radiator 14 code. Any other helps is good...Thanks! 7 Answers

before it stalls engine light comes on all the time before it stalls...Code 42 and code 14 is what I got...I am going to change the crank sensor in the morning to see if this helps...but I am welco...

1991 Chevrolet Lumina Euro Sedan FWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.