ford bantam 1.6 cranks does not start

Asked by tongai shatmo Sep 03, 2021 at 04:09 AM about the Ford Bantam

Question type: Maintenance & Repair

i have a ford bantam 1.6 just cranks does not start.battery voltage 12.65v but
when i jump start no problem for the whole day where is the problem please
help

2 Answers

16,935

Cranks, but does not start. The starter solenoid wire is running in the same channel as the crank angle sensor. When the starter solenoid is energized this induces a higher voltage into the crank angle sensor wiring. Move this solenoid wire out of the crank angle sensor wiring channel. Check the condition of the main starter cable from the battery to the starter. Clean the terminals and the amperage draw on this cable. Check the earth cable from the battery negative to the body and fit an extra earth cable from the battery Neg terminal to the gearbox.

Your Answer:

Bantam

Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,620
  • #2
    MrRocket12
    Reputation
    1,150
  • #2
    Janus Welgemoed
    Reputation
    1,150
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.