Ford Bantam Rocam 1.3 don't want to start

Same with any no start , check for proper spark , fuel pressure and injector pulse .

Is it not cranking or starting ? or cranking and not starting ? Cranks but not starting Cranks, but does not start. The starter solenoid wire is running in the same channel as the crank angle sensor. When the starter solenoid is energized this induces a higher voltage into the crank angle sensor wiring. Move this solenoid wire out of the crank angle sensor wiring channel. Check the condition of the main starter cable from the battery to the starter. Clean the terminals and the amperage draw on this cable. Check the earth cable from the battery negative to the body and fit an extra earth cable from the battery Neg terminal to the gearbox.

PATS Warning light flash codes When you switch the ignition to the ON position the Light next to the clock (Immobilizer Warning light) comes ON and then goes OFF. This shows that the system is OK If the Light flashed quickly and then switches OFF and starts flashing a "1" or a "2" and switches OFF and the starts to flash um a "1" to "6" , or say 1 3 or 86 If this light does not come on at all or stays on with the ignition on, there is a problem in the PCM / ECU All the fuses and Relays must be check first.