I have a 2004 ford bantam rocam 1.3 there is no fuel supply replaced new pump checked pump is working there is no power supply to pump checked fuses all good checked cutt off switch ok cleaned power lug under driver seat bakkie still refuse to start
it hasn't got one of these fancy-shmanzi security enablers, does it? This could have the high-pressure fuel panic button, located drivers footwell which shuts off all fuel on a collision to stop high pressure fuel spray in an accident. These fords are famous for this inconvenience in the name of safety. When you say checked butt off switch, did you mean this 'panic fuel shutoff?' cause this is going to be my only guess, which should have you back up as fuel pressure is restored. perhaps you hit the wrong button.
Check the electric wire coming from the petrol tank that powers the pump in the tank under the bakkie,could be disconnected before it gets to the fuse box
...well maybe, but there is a "panic button"...think that is red and about 1/4" in diameter...may be under the dash on the left side of the kick panel~...you can't miss it~
Check my answer to pieter, same problem
You need to find your relays...they may be hidden behind the Fuse box. If so..remove the fuse box and make sure all the relays are properly pushed in.
The inertia switch for these Bantams is behind the left side panel on the 'A' pillar . They is a hole in this panel and a button. Press the button in. These bakkies are equipped with the manufacturers PATS security system so there is no need to install another system.
Good day.Im sitting with the same problem and have check my relay as well as my cut of switch,and still no power to my fuel pump.what can have i missed that could cause this problem?
When you switch on the ignition, does the fuel pump operate for a few seconds ? Have you tried swapping the fuel pump relay with one of the other relays ? Try a live straight to the fuel pump. Check the spade terminals where the male part of the relay terminal connects into, the spade terminal might be spread out a bit. Get a small flat screw driver and close the spade section in a little.
Hi good day I have a 2005 year ford bantam rocam I fil feul but still so me there is no feul
If that is according to the Gauge ? Check the wiring to the fuel tank. Perform a Instrument Cluster self test :To activate the Cluster self Test for Bantam , Fiesta and Ikon : Switch the ignition to OFF and press the ODO trip button IN and hold, then switch the ignition ON and wait till the ODO display, displays TEST. The Gauges will go to full sweep and back. Press the ODO trip button again to go to the next test. Carry on through the tests. To exit the self test , switch off the ignition.
