oi installed a after market cold air intake and then started it and it dies.
I installed a after market intake and when I
start it it dies
beatupchevy answered 4 years ago
It's usually best to go with how the car was designed , a sensor ( MAF/MAP ) may be getting a bad signal
I installed a after market intake and when I start it it dies
Ford Taurus
-
Maintenance & Repair
My son was going to drive it to work after he had ptu a new water pump on it to try it out. He got on the road real good and everything was going find,then all of a sudden the car started to shake r...
2001 Ford Taurus SES
-
Maintenance & Repair
heat problem luke warm and sometimes hot, gauge stays on cool then at idle sometimes goes to half way where it belongs and heat works, but most of time stays luke warm, coolent is full?
2003 Ford Taurus SE
-
Maintenance & Repair
My car's heat is blowing cold air and when I start it the battery light lights up as well and drove for about 5min,but now the car won't start and when I try to start it I here some noise.
2000 Ford Taurus SES
-
Maintenance & Repair
the vacuum line for the intake manifold came off and then it started throwing the p174 and p304 codes, I have changed the fuel filter some of the egr vacuum lines and changed the plugs all that, took ...
1999 Ford Taurus SE
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.