4.3 vortec
Seen a blue prints many years ago for the 4.3
bored and honed to put out 501 horse . Anyone
know where to find such blueprints that I know
exist just cant remember where or what magazine I
seen it in
Asked by Blueblazer2000 Sep 15, 2019 at 04:57 PM about the Chevrolet Blazer
Question type: Maintenance & Repair
Seen a blue prints many years ago for the 4.3
bored and honed to put out 501 horse . Anyone
know where to find such blueprints that I know
exist just cant remember where or what magazine I
seen it in
Seen a blue prints many years ago for the 4.3 bored and honed to put out 501 horse . Anyone know where to find such blueprints that I know exist just cant remember where or what magazine I seen it...
Chevrolet Blazer
-
Maintenance & Repair
I'm still working on my 95 s10 blazer 4.3 vortec vin 4 it is idling rough & fouling plugs with black Sutt but is will rib up acts like the mass air flow sensor but don't have one I changed the o2...
1995 Chevrolet Blazer LS 4-Door RWD
-
Maintenance & Repair
Replaced lower intake gasket, so had to pull the distributor obviously, and now I'm running into a problem where it's not starting we did mark it and it's lined up with the marks. And now it sounds...
2000 Chevrolet Blazer LS 4-Door 4WD
-
Maintenance & Repair
4.3 vortec runs great then dies when it hits running temp . No DTC. STILL have spark and fuel pressure. New sending unit. filter . Press. reg. ICM. Coil . Crank sensor. Wont start till it s...
1997 Chevrolet Blazer LT 4-Door 4WD
-
Maintenance & Repair
will a 4wheeldrive transmission work in a 2wheeldrive, both transmissions hook up to 4.3 engines
1998 Chevrolet Blazer 4-Door RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.