Getting 4.3 vortec to start

160

Asked by Jaymz21 Sep 30, 2017 at 01:28 AM about the 2000 Chevrolet Blazer LS 4-Door 4WD

Question type: Maintenance & Repair

Replaced lower intake gasket, so had to pull the
distributor obviously, and now I'm running into a
problem where it's not starting we did mark it and
it's lined up with the marks. And now it sounds like
it's ready to fire, we had sprayed some starter fluid
in the intake and then tried to start it, and it shot
off one of the vacuum line 90° tubes. There is
spark and fuel(not much but enough) and unsure
about timing but everything seems lined up. Any
advice?

45,195

jamnblues answered 7 years ago

naw, I can't give advice on something I'm not willing to do myself- and I am NOT gonna even open the hood on one of these 21st Century GM products- hey! at least I responded if not sympathetically-

Mark helpful

Your Answer:

Getting 4.3 vortec to start 1 Answer

Replaced lower intake gasket, so had to pull the distributor obviously, and now I'm running into a problem where it's not starting we did mark it and it's lined up with the marks. And now it sounds...

2000 Chevrolet Blazer LS 4-Door 4WD

-

Maintenance & Repair
4.3 vortec 1 Answer

Seen a blue prints many years ago for the 4.3 bored and honed to put out 501 horse . Anyone know where to find such blueprints that I know exist just cant remember where or what magazine I seen it...

Chevrolet Blazer

-

Maintenance & Repair
97 4.3 vortec randomly dies wont start till its sat for about an hour 3 Answers

4.3 vortec runs great then dies when it hits running temp . No DTC. STILL have spark and fuel pressure. New sending unit. filter . Press. reg. ICM. Coil . Crank sensor. Wont start till it s...

1997 Chevrolet Blazer LT 4-Door 4WD

-

Maintenance & Repair
95 s10 blazer 4.3 vortec vin w rough idle 1 Answer

I'm still working on my 95 s10 blazer 4.3 vortec vin 4 it is idling rough & fouling plugs with black Sutt but is will rib up acts like the mass air flow sensor but don't have one I changed the o2...

1995 Chevrolet Blazer LS 4-Door RWD

-

Maintenance & Repair
I have a 1999 Chevy Blazer, 4x4, 4.3 vortec. We have changed the coil pack, fuel filter, distributor cap and button, the crank shaft sensor, cam sensor and plug wires as well as the ignition control module. We coming to a stop sign it will stall and sometimes when just sitting still. Sometimes it will start right back up and other times it takes several tries. I also have the oxygen sensor on order and it should be here tomorrow. Fuel pressure tested perfectly. No black smoke, no smell of rotten eggs or the cat glowing red. The only code that comes up is PO420. 4 Answers

I have a 1999 Chevy Blazer, 4x4, 4.3 vortec. We have changed the coil pack, fuel filter, distributor cap and button, the crank shaft sensor, cam sensor and plug wires as well as the ignition control m...

1999 Chevrolet Blazer 4-Door 4WD

-

Maintenance & Repair

Used Chevrolet Tahoe

20 Great Deals out of 904 listings starting at $11,900

Used Jeep Grand Cherokee

122 Great Deals out of 3,221 listings starting at $4,995

Used Chevrolet Silverado 1500

195 Great Deals out of 5,967 listings starting at $2,975

Used Toyota RAV4

100 Great Deals out of 2,089 listings starting at $3,888

Used Ford Explorer

87 Great Deals out of 2,048 listings starting at $2,999

Used Honda CR-V

99 Great Deals out of 3,843 listings starting at $1,795

Used Toyota 4Runner

12 Great Deals out of 309 listings starting at $9,700

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

Getting 4.3 vortec to start

1 Answer

Your Answer:

Shortcuts

Search Chevrolet Blazer Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

Getting 4.3 vortec to start

1 Answer

Your Answer:

Related Questions