new heater fan fuses resistor switch and relays fan still does not work
2008 cobalt fan not working only 4 volts going to plug in is that enough to run
fan? goes to 0 when switch is off that's good
Asked by Guru9ZQ265 Dec 11, 2020 at 06:38 PM about the Chevrolet Cobalt
Question type: Maintenance & Repair
2008 cobalt fan not working only 4 volts going to plug in is that enough to run
fan? goes to 0 when switch is off that's good
Should be around 12 volts to the fan on High. 4 Volts is not enough.
2008 cobalt fan not working only 4 volts going to plug in is that enough to run fan? goes to 0 when switch is off that's good
Chevrolet Cobalt
-
Maintenance & Repair
my 2008 chevy cobalt ac wont come on, checked the fuses , wires, senor, resistor, relay,switch , and blower motor fan still will not work.
2008 Chevrolet Cobalt LT Sedan FWD
-
Maintenance & Repair
I checked the fuse, the relay, and put in a new sensor. The fan runs all of the time when I unplug the sensor but will not come on when I plug it back in no matter how hot it gets.
2007 Chevrolet Cobalt
-
Maintenance & Repair
My cooling fan does not kick on at all. I just replaced the fan today and nothing. Ive tested each relay with 12 volts and even checked the resistance of it, they all read 0.00. The fuses are good a...
2005 Chevrolet Cobalt LS Coupe FWD
-
Maintenance & Repair
I have a 2007 cobalt and my cooling fan doesnt turn on. I have replaced the temp sensor and also the relay for the low fan setting with no luck. Have also pulled the fan off and hooked it straight u...
2007 Chevrolet Cobalt LT Sedan FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.