would i have low compression on all cylinders cold if the lifters weren't pressing up?

would i have low compression on all cylinders cold if the lifters weren't pressing up? 1 Answer

I have a 2008 Chevy Silverado 5.3. Truck idles good when in park but when I put it into gear the check engine light comes on. P0307, witch is Cylinder 7 misfiring. Ive changed all the lifters,coils,injectors and solnoids. Plugs and wires as well. Even turned off the AFM to see if that would help. cleaned the pushrods, made sure they worked. valley cover has been cleaned as well 2 Answers

I have a 2008 Chevy Silverado 5.3. Truck idles good when in park but when I put it into gear the check engine light comes on. P0307, witch is Cylinder 7 misfiring. Ive changed all the lifters,coils,in...

low beam wont come on until I raise the column up--Then low beam comes on!! 3 Answers

The wire connections in the column are causing the low light beam shut off until I raise the column or reach under the coloumn and move the wires a little''' Now that I unplugged the connection to che...

I have a 1991 Silverado. The oil pressure gauge suddenly shot up to the max. Would that be the sensor going out? Can I drive the truck? 2 Answers

The truck suddenly just stopped running. After a few minutes it started up and ran fine but the oil pressure gauge went to the max. I drove home (20 miles) without any problem but would that be the ...

I have a 85 chevy and on the way home after filling it up in stopped running. It would not fire from that point on. What could cause it not to fire? 3 Answers

I have checked all the plugs and wires, replaced the coil, the ignition module, and checked fuses under dashboard. Still doesn't fire. What else can I try? 1985 model