callahanpoppy answered 4 years ago
Could be the switch itself is bad. Suggest you find a recycler/dismantler to see if you could get one to test, before you replace. It's a job cause the steering column needs to be removed to access usually. Some have it where access is possible by just removing steering wheel. BUT ONLY IF YOU HAVE NO AIRBAG! Best let mechanic you trust to handle this.
The blinkers and running lights work but no headlights bulbs are good
Dodge RAM Van
-
Maintenance & Repair
Driving down the road runs fine when come to stop have to Put in neutral to keep it running
2000 Dodge RAM Van 1500 Cargo RWD
-
Maintenance & Repair
Headlights went out, no tail lights, brake lights, dash lights and power locks quit all at once.
1990 Dodge RAM Van B250 Cargo RWD
-
Maintenance & Repair
I have a 1996 Dodge ram full cargo B1500 with over 270K miles. It will run well for several miles and then start bogging, as if a potato is stuck in the tailpipe. Mechanics down at the shop have no id...
1996 Dodge RAM Van 1500 Cargo RWD
-
Maintenance & Repair
In cold weather a dodge ram 250 van v-6 crank for a few minutes , there are no power to the ignition cap or coil and won't start until after a clicking sound stop.
1993 Dodge RAM Van
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.