2001 Mercedes ML 320
Asked by Meohmy1 Nov 30, 2015 at 11:49 AM about the Mercedes-Benz M-Class
Question type: Maintenance & Repair
Hello
my mercedes started sputtering abit, i stop and park it. I try to start it and it it starts but the fluctuites and stalls ...idles high then it putters for a bit then stalls.
check engine light went on
i checked the MAF it is ok...any ideas or suggestions????
13 Answers
check IAC, TPS, CPS and CSPS
Thank you I have recently (2 weeks ago) changed my Crank Position Sensor. any easy way to check the TPS or IAC
You need to have the codes read stop by a Auto Zone or advanced Auto parts and have them read for free and post here for help....
I thought that CPS was the crank position sensor...if CSPS is the sensor then what is CPS? Thank you
cps is crank position sensor csps is crankshaft position sensor
My apologies...so they are both different?i thought they were the same. i did change the cps where is the CSPS located? Thanks again
Hi everyone I ran a scan and it reads no codes But what it did display on my below my speedometer was start error I turn it over and it runs for a sec then stalls Going crazy R
When it first started having problems it drove great then a couple times chugged like the choke was on.Then it drive ok and finally stalled. It would start idles slow then high then stall. M Now it starts then dies
My battery is dead and I am using a boost...would that make a difference in the reading I unplugged the maf to see if there was a difference..not
I did notice a few weeks back it would idle slow at lights where I thought it may stall but it never did.