How do I replace the sensor ring on a 2011 Dodge Ram 1500 4X4

Asked by elsie Mar 28, 2023 at 06:00 PM about the Dodge RAM

Question type: Maintenance & Repair

Did a complete rear brake replacement on 2011 Dodge Ram 1500. Replaced

speed sensors.  The root problem was The e-brake was broken apart on the

driver side which caused a bit of damage to the ABS sensor ring didn’t seem

too serious so we put the thing back together Now the ABS and Service 4X4

lights won’t go out would wear on the cog ring cause this or could it be wiring.

1 Answer

157,625

Make sure the reluctor ring (that's the "sensor ring") is not dirty, damaged, or too far away from the speed sensor. Also check the wiring and plugs for the sensors. Make sure you got the correct drums or rotors for the back too! Hope that helps! Jim

Your Answer:

CarGurus Experts

  • #1
    Kristi Barney
    Reputation
    1,080
  • #2
    4x4greendodgeram
    Reputation
    620
  • #3
    maddog10931
    Reputation
    530
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.