replaced camshaft sensor connector on hyundai 2000 2.4L. new pigtail has 3 black wires and engine has 2 black and 1 brown wire. what is the proper connection

Asked by slamzilla Sep 02, 2013 at 12:26 PM

Question type: Maintenance & Repair

200,975

dandyoun answered 11 years ago

Ok if I understand you correctly you are replacing the connector. Does new connector itself look like the old one? if so Hold both connectors in your hand the same way. Using old connector as a pattern and hook up new one one wire at a time so that the wires from old connector are hooked to the same pin on new connector as they were on the old one.

Mark helpful

slamzilla answered 11 years ago

no

Mark helpful

Your Answer:

replaced camshaft sensor connector on hyundai 2000 2.4L. new pigtail has 3 black wires and engine has 2 black and 1 brown wire. what is the proper connection 2 Answers

Hyundai

-

Maintenance & Repair
I have a 2005 Hyundai Sonata, When I start it runs fine for 15min, then shuts off, no codes given but the letter O, C and E blink on my OBD II reader. I replaced the O2 sensors& camshaft sensor 3 Answers

I replaced the camshaft and crankshaft sensor , idle control valve, EGR, o2 sensors, PCV valve. Justs keeps shutting off after it warms up. I need some help

2005 Hyundai Sonata V6 GLS FWD

-

Maintenance & Repair
what is the meaning of 3 chimes and a snowflake symbol on the 2015 Hyundai Accent 17 Answers

While driving, there is 3 chimes and a small indicator light of a snowflake comes on near the temperature indicator. What does this mean?

2015 Hyundai Accent GLS 4-Door Hatchback FWD

-

Maintenance & Repair
2011 Hyundai Sonata--I changed my battery on Saturday morning and the ck engine light came on. I followed the instructions in the forum and disc the cables for 1/2 hour then connected the negative cable first then the positive. Light went out than came back on. Went to Autozone and had them run a scan that showed P0106 MAP sensor fault so I replaced the sensor with a brand new one $81.00 and the light was still on. Again I disc the cables and the ck engine light turned off but again turned on. Drove close to 75 miles and still on. I went back to Autozone this morning and when they attached the code reader the light turned off. I drove less than 1/4 mile and it is on again. PLEASE HELP! 2 Answers

2011 Hyundai Sonata--I changed my battery on Saturday morning and the ck engine light came on. I followed the instructions in the forum and disc the cables for 1/2 hour then connected the negative c...

2011 Hyundai Sonata SE FWD

-

Maintenance & Repair
I have replaced the battery and put a new starter in my 2009 santa fe and it still will not start. What is going on?? 4 Answers

I have replaced the battery and put a new starter in my 2009 santa fe 3.3L and it still will not start. What is going on??

2009 Hyundai Santa Fe 3.3L Limited AWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.