I was just curious, engine cranking, do you have spark at the plugs and fuel injector pulse? If your missing everything, have to check for rpm signal. Any applicable trouble codes? Engine cranking, I can't hear the fuel pump. Now, key on engine off, fuel prime is one thing, but will the pump run engine cranking? Is the fuel line blocked?
Just to add, there is gas in the gas tank? 3.0L fuel pressure 35--45 psi, so if your right in the middle should be ok.
While I was driving I lost all fuel pressure, it's not out of gas I connected a fuel pressure guage to the fuel rail and it shows 0 psi and the relay works. I have no idea what the issue could be a...
1988 Ford Ranger XLT Standard Cab 4WD LB
-
Maintenance & Repair
I have put a new fuel pump fuel filter relays and still I'm not getting fuel up to my injectors fuel pump is kicking on fuel pump relay is also working
1995 Ford Ranger XLT Standard Cab SB
-
Maintenance & Repair
I have a 1996 Ford Ranger 4.0 with manual transmission. Driving about 65 MPH and noticed the oil pressure sensor had dropped. Pulled over and stopped car. No smell or smoke, check oil and it's ful...
1996 Ford Ranger XLT Standard Cab SB
-
Maintenance & Repair
With a gauge on the fuel rail the pressure checks OK.40# with just key on and 35# running sitting in the driveway. It goes up when you take the vacuum line off and it also hold pressure well when tur...
1987 Ford Ranger
-
Maintenance & Repair
2002 explorer, no fuel pressure, new fuel pump, has power to pump, the relay has one hot wire and one hot wire with the key on. Not sure where to go from here.
2002 Ford Explorer XLS 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.