What is the best way to get at the Distributor, Spark Plugs, and Ignition Wires?

275

Asked by Sport Jul 15, 2011 at 01:29 PM about the 1993 Chevrolet Chevy Van G30 RWD

Question type: Maintenance & Repair

I was looking to tune up my 1993 G30 Cargo Van by replacing the distrubtor, plugs and wires, do an oil change, etc etc as I just bought it used. What is the best way to get at the Distributor, Spark Plugs, and Ignition Wires? Please keep in mind that I do not have a hoist, but I do have access to electrical and part location diagrams. I am familiar with where these pieces are and how to replace them (if I can get at them), but I am unable to reach them from the front of the engine/vehcile. Any ideas? Should I jack up the van, put it on stands and come at it from underneath to get the back 4 plugs and wires? (5 & 7, 6 & 8).. Any tips for doing this in the yard would be greatly appreciated.

635

Mathieu answered 13 years ago

LOL the acces is by the inside of the van..remove the center console..(one clip each side or maybe two 13mm bolts ) everything can be done by the interior..distributor is at the back of the engine ;)..firring order=1-8-4-3-6-5-7-2 ;)

5 people found this helpful.

Mark helpful

635

Mathieu answered 13 years ago

be gentle with the distributor cap screws..they are very easy to broke ;)..

1 people found this helpful.

Mark helpful