Should I be building pressure on #1 Cylinder as my timing marks align?

Should I be building pressure on #1 Cylinder as my timing marks align? 1 Answer

My oil pressure gauge doesn't work, should I be concerned? 2 Answers

When my truck is off my gauge is at 40, and when it's on and running it's past 80. It runs fine and I'm always on top of oil changes, but I don't know if I should be concerned about an underlyin...

i replaced my throttle positioning sensor. i may have to change the pressure sensor on my fuel tank. my service engine light is on and my truck stalls as if it is not getting any fuel.how do i bypass 4 Answers

tps replaced..if i start my truck and the service engine light is on my truck will stall out. if the service light is off the truck is fine. i know it is a sensor but how can i bypass it...if i keep ...

I replace the master cylinder and front brake calipers on my 2005 Chevy Silverado 1500 5.3 liter I bled the system numerous times and I still cannot get a break that'll back what would be the reasons 5 Answers

I replace the brake calipers and the master cylinder on my 2005 Chevy Silverado 1500 5.3 liter and still cannot get brake pedal back I've bled the system there's times what else could it be

What gear oil should i use in the rear differential on my 2007 silverado 2wd 1500? 4 Answers

My 2007 silverado 1500 has over 126,000 miles on it and I need to change the rear diff oil. I drive 100 miles a day round trip to work and back, mostly on the interstate. I rarely haul any heavy loads...