Transmission "clunks" going into reverse
Tranny "clunks" going into reverse. All other gears seem fine (no noise/smooth). Only
other problem is slight "shimmy" above 60 MPH. Not sure if that's related or not.
Asked by KGarber1 Jul 14, 2015 at 02:47 PM about the 2006 Ford Explorer XLS V6 4WD
Question type: Maintenance & Repair
Tranny "clunks" going into reverse. All other gears seem fine (no noise/smooth). Only
other problem is slight "shimmy" above 60 MPH. Not sure if that's related or not.
firebird338 answered 9 years ago
Check universal joints
Tranny "clunks" going into reverse. All other gears seem fine (no noise/smooth). Only other problem is slight "shimmy" above 60 MPH. Not sure if that's related or not.
2006 Ford Explorer XLS V6 4WD
-
Maintenance & Repair
I have over 200,000 miles on my 2005 Ford Explorer XLS and have kept it service, but I have never serviced the transmission. Have anyone experience this on your vehicle.
2005 Ford Explorer XLS V6
-
Maintenance & Repair
Just put a used transmission gears works but it will not go into Reverse
2007 Ford Explorer XLT
-
Maintenance & Repair
my transmission will only go in reverse, 1996 ford explorer, tried adding tranny fluid, stop slip, going thru PRND21 in 2WD 4WD and 4WDL, plus transfer case bolt replaced before break down.
1996 Ford Explorer 2 Dr XL 4WD SUV
-
Maintenance & Repair
Will a 1998 ford explorer transmission fit into a 1993 Ford explorer.
1993 Ford Explorer 4 Dr Limited 4WD SUV
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.