Asked by Clifford Jan 09, 2017 at 09:18 PM about the 2006 Ford Explorer XLT V6
Question type: Maintenance & Repair
I replaced the harmonic balancer and timing sensor, after test driving I now
have a code P0340 camshaft sensor "A"- circuit malfunction (bank 1) any
suggestions how to correct it.
Possible causes - Faulty Camshaft Position Sensor - Camshaft Position Sensor harness is open or shorted - Camshaft Position Sensor circuit poor electrical connection - Faulty starter motor - Starting system circuit - Dead (Weak) battery.
I replaced the harmonic balancer and timing sensor, after test driving I now have a code P0340 camshaft sensor "A"- circuit malfunction (bank 1) any suggestions how to correct it.
2006 Ford Explorer XLT V6
-
Maintenance & Repair
I have replaced the crankshaft sensor, alternator,harmonic balancer, camshaft sensor,new belt, car runs great but the DTC dash lite comes on and my code reader reads P0340 camshaft sensor error.
2006 Ford Explorer XLT V6
-
Maintenance & Repair
Is there a way to know if it is bad? I replaced my multi-v belt and it keeps on slipping off. I notice that the fan pully (harmonic balancer) is lose. Is there a way to tighten it?
1992 Ford Explorer
-
Maintenance & Repair
I have had top end engine noise. I have changed out the rocker arms and push rods. That helped with the chatering but there is a knocking noise. I suspect it's coming from the lifters/camshafts. What ...
1992 Ford Explorer 4 Dr XLT 4WD SUV
-
Maintenance & Repair
When I am in a stopped position and turn left or right the rear end seems to make a sound as if something is grinding.I have also seen this if i pull up my slightly inclined driveway.
1996 Ford Explorer 4 Dr XLT SUV
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.