Does a 1990 and a 1995 dodge 318 have the bolt locations in the same spot.can I put alternator and all pulleys from the 90 on the 95

Asked by Thebassgod Nov 15, 2015 at 07:08 AM about the 1990 Dodge RAM 150 LE LB 4WD

Question type: Maintenance & Repair

I can get a 1995 dodge 318 out of a dodge van in order to get it to work ,I am
wondering if my timing chain cover and all bolt locations will be in the same
spot on both motors so I can use all my timing chain cover on this motor plus
my alternator power steering pump etc on the motor with no problem.any
help would be appreciated , I don't want to buy this motor and find out it
won't work

224,155

Rowefast answered 9 years ago

I am not going to tell you to buy that engine, but my opinion is that yes, the bolt hole locations should be the same. 90% sure. My concern would be bolting the alternator and power steering on, but there is usually a way. The bell housing bolt holes will line up with the back of the motor, motor mount locations are the same, starter no problem, It will drop in and bolt up.

Mark helpful

224,155

Rowefast answered 9 years ago

Also when doing something like this, you need to set up the motor going in as the same as the one coming out. Fuel delivery system, and all sensors, as your ecm (brain) is set for that vehicle...

Mark helpful

Your Answer:

Does a 1990 and a 1995 dodge 318 have the bolt locations in the same spot.can I put alternator and all pulleys from the 90 on the 95 2 Answers

I can get a 1995 dodge 318 out of a dodge van in order to get it to work ,I am wondering if my timing chain cover and all bolt locations will be in the same spot on both motors so I can use all my ...

1990 Dodge RAM 150 LE LB 4WD

-

Maintenance & Repair
I have a 1990 Dodge Ram that the 318 needs to be pulled. Can I replace the 318 with a 1995 318 and if so will the wire be the same for all sensors and will there be any benefits with the newer 318 2 Answers

My motor has rusted out freeze plugs in back of block and has high miles...does the newer 318 have more horsepower and the same sensors. Are there any benefits to the newer motor , it has 150,000 mi...

1990 Dodge RAM 150 LE LB 4WD

-

Maintenance & Repair
I have a 1983 Dodge D150 automatic-318 motor. Question, when I disconnected my radio (removed red wire (power) orange wire and ground wire-from that point on I have no power to the ignition key. My h 4 Answers

1983 Dodge D150 pickup-318 engine-automatic transmission battery is good turn starter key -no power head lites work-interior lites work-tail lites work turn sigs do not work wipers do not work power...

1983 Dodge RAM 150 RWD

-

Maintenance & Repair
i have problem with my truck i put a new alternator new batteries and still not working theirs a light come up on the desk bord check the gagges so plese anybody can help me out i have my truck since 2001 i never have any problem untill now thank you 2 Answers

the alternator drain the batteries

Dodge RAM 150

-

Maintenance & Repair
With the key off the three brake lights work correctly when the brake pedal is depressed. With the key on the two rear brake lights stay on all the time and the third brake light works correctly when the pedal is depressed. Also, The cruise control does not work. This all started after had the dash appart trying to repair a problem with the defroster. The brake light switch was replaced to no avail 2 Answers

With the key off the three brake lights work correctly when the brake pedal is depressed. With the key on the two rear brake lights stay on all the time and the third brake light works correctly when ...

Dodge RAM 150

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.