beatupchevy answered 7 years ago
it's probably a hydraulic clutch , is the pedal stiff or sloppy ? There is a bleeder on the tranny. and a reservoir under the hood , don't force it into gears you'll ruin it
Could be the clutch pressure plate, throw out bearing, clutch slave cylinder or master cylinder. Most likely is the clutch slave cylinder has gone bad. Check the fluid in the clutch reservoir.
1991 ranger 4.0 manual 5spd clutch will not disingadge
1991 Ford Ranger XLT Extended Cab SB
-
Maintenance & Repair
My 1991 Ford ranger is have starting issues it just had it clutch replace and once we got it in it won’t start again I have tried everything like replacing the starter and starter solenoids and it...
1991 Ford Ranger
-
Maintenance & Repair
My Truck ran out of gas and i put gas in it and it still won't crank. So i sprayed some starting fluid (ether) in it and it still won't crank which means the spark plugs are sparking (won't fire). w...
1991 Ford Ranger XLT Standard Cab SB
-
Maintenance & Repair
Hello, One of my 88 Ford Rangers has a 2.9 V6 w/5 speed Mit. transmission. Several years ago we put in a new clutch, pressure plate, throw out bering and clutch slave. Within the past several weeks ha...
1988 Ford Ranger
-
Maintenance & Repair
What transmission is interchangeable with a 1991 ford ranger, extend cab, V6 (4.0), 2 wheel drive
1991 Ford Ranger
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.