got no power to the instrument cluster
1 Answer
beatupchevy answered 7 years ago
a fuse may have blown in the process , any time you disconnect the batt. on these newer vehicles you need a memory saver ,
1 people found this helpful.
beatupchevy answered 7 years ago
a fuse may have blown in the process , any time you disconnect the batt. on these newer vehicles you need a memory saver ,
installed a new starter,but no power to the dash.
2002 GMC Sierra 2500 4 Dr SLT 4WD Extended Cab SB
-
Shopping & Pricing
How is the power and reliability in the engine? I can buy one with only 99,000 kms on it.
1996 GMC Sierra 2500
-
Shopping & Pricing
smokes at all times but runs good no injector codes contribution all pretty typical 678 to 681
2003 GMC Sierra 2500 4 Dr SLT 4WD Extended Cab SB
-
Maintenance & Repair
took thermostat off, bled lines ran cool for quit a way and slowly started getting hot. turned off truck for not eve 5 mins. and turned key over it was still a lil hot but didnt sit long enough to c...
2000 GMC Sierra 2500 3 Dr SLE Extended Cab LB HD
-
Maintenance & Repair
(1995 GMC Sierra 2500 Pickup, 305 V8, Automatic Transmission, rear wheel drive, 85,000 miles) Once in gear it will normally require me lightly pumping the gas to keep from dying. Too much gas and it...
1995 GMC Sierra 2500 2 Dr C2500 SL Standard Cab LB
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.