whats done during the intake valve job?

Asked by Guru9CSNDQ Jul 26, 2021 at 03:23 PM about the 1995 Oldsmobile Cutlass Supreme 4 Dr S Sedan

Question type: Maintenance & Repair

I had an oil leak and took it in for intake valve job .....when doing a intake valve
job for cutlass supreme Oldsmobile 1995, is it customary check and make sure
o ring is not leaking and if so fix it too at same time?

F_O_R answered 3 years ago

The valve seals should be replaced when doing the valves. If the valve guides are worn they should also be replaced.

1 people found this helpful.

Mark helpful

Your Answer:

whats done during the intake valve job? 1 Answer

I had an oil leak and took it in for intake valve job .....when doing a intake valve job for cutlass supreme Oldsmobile 1995, is it customary check and make sure o ring is not leaking and if so fix...

1995 Oldsmobile Cutlass Supreme 4 Dr S Sedan

-

Maintenance & Repair
What is the best way to wash a car with a primer paint job? 1 Answer

My '72 Cutlass supreme has a grey primer finish. I know this question isn't directly for the cutlass but if you guys can help me out with it that would be great. Or whats an alternative ? maybe just...

1972 Oldsmobile Cutlass Supreme

-

Maintenance & Repair
When i turn my car on the temp gauge goes up to hot even tho the e gines cold. It goes back down for a minute then rises again. First snow of the yr today and my heat wont work either whats wrong? 2 Answers

after car is warmed up the temp gauge keeps going up and down and heat is still blowing cold air

1997 Oldsmobile Cutlass Supreme 4 Dr SL Sedan

-

Maintenance & Repair
My Oldsmobile temperature gage inside the car will show over heating with needle going to max temp and seconds later going back to normal temperature just as quick. I have replaced the intake manifold gasket, temperature sensor, thermastat and radiater cap. I also have tried to burb the system by placing a no spill funnel on the radiater fill inlet and let run for over an hour. The car would burp every few minutes when what I believe was when the thermostat opened and that is when the temp gage inside would go to the max. 2 Answers

My Oldsmobile temperature gage inside the car will show over heating with needle going to max temp and seconds later going back to normal temperature just as quick. I have replaced the intake manifo...

1993 Oldsmobile Cutlass Supreme 2 Dr STD Convertible

-

Maintenance & Repair
Cutlass cierra s 93 had my suspension done I went over a bump 6 months later an the strut mount failed while I was driving only 77 thousand miles 2 Answers

My mechanic said they didn't have nothing to do with it that it's the mount on top were the bolt is

1993 Oldsmobile Cutlass Supreme 4 Dr S Sedan

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.