I have a 1998 pontiac grand am. When I turn the wheel right it makes a grinding noise. I replaced both cv shafts. What else can it be?

Asked by dustinpeterson Sep 29, 2013 at 10:16 PM about the 1998 Pontiac Grand Am 4 Dr SE Sedan

Question type: Maintenance & Repair

I have a 1998 grand am. When I turn the wheel right it makes a grinding noise. I replaced both cv shafts. What else can it be?

operator_13 answered 11 years ago

take a look at the motor mounts for degradation...may need a floorjack and woodblock to prove my point~

Mark helpful

GuruCXXX4 answered 5 years ago

That's what happened to me an motor mount it was

Mark helpful

Your Answer:

I have a 1998 pontiac grand am. When I turn the wheel right it makes a grinding noise. I replaced both cv shafts. What else can it be? 2 Answers

I have a 1998 grand am. When I turn the wheel right it makes a grinding noise. I replaced both cv shafts. What else can it be?

1998 Pontiac Grand Am 4 Dr SE Sedan

-

Maintenance & Repair
I have a pontiac grand am 2005 and had the ignition replaced. It started for a while then it quit starting. It wont even turn over. The battery and alternator are good. What can it be. 1 Answer

I had the ignition replaced and the sensor monitor checked out fine. The battery and alternator are good. The car wont even turn over when I try to start it.. Got a jump and it didn't work.

2005 Pontiac Grand Am SE

-

Maintenance & Repair
i have a 1998 Pontiac grand am 4cyl. 2.4 l ohc engine and when I turn on the heat the temperature gauge gauge goes almost to the dangerous level.when I turn it off it goes back to normal.what would cause this and how can I fix it? 1 Answer

my 1998 Pontiac grand am 4cyl. 2.4 l ohc engine is oveheating when the heat is turned on .the tempature gauge goes almost to the top with the heat on then returns to normal after I turn the heat off.w...

1998 Pontiac Grand Am

-

Maintenance & Repair
While driving, there is a grinding noise when I turn the wheel right. 1 Answer

This noise appeared 10-20 miles after I changed the passenger side drive/half shaft (some of that noise could have been there before I changed this, just not the grinding when turning). There was also...

2004 Pontiac Grand Am SE

-

Maintenance & Repair
I have a 2000 Pontiac Grand am when I turn the ignition to start it dies and also I have 3 lights on the security light,service engine and TRAC OFF light what doies this mean? 8 Answers

You can start it and it dies right away like there is no fuel and it has a new pump n filter. also a few lights are on the service engine light,security light and now a TRAC OFF light!

2000 Pontiac Grand Am SE

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.