my blower will not turn on, however the blower motor is correctly working? does a;nyone know what this could be?
On 2006 chevy impala my heater fans will not turn on , however the blower
motor was tested and is working properly.
There is a resistor pack that sits on or near the blower motor tht controls voltage to it. Usually when the resistor pack goes, the blower motor will only work on it's highest setting. If you get no voltage to the motor no matter what setting you have, high included, you'll need to troubleshoot the wiring harness, at least back to the fan switch.
On 2006 chevy impala my heater fans will not turn on , however the blower motor was tested and is working properly.
2006 Chevrolet Impala LS FWD
-
Maintenance & Repair
ok i have replaced my blower resistor and blower control but it still does not work i even got a different blower motor and it still doesn't work, ive tested with a voltmeter and its getting power b...
2002 Chevrolet Impala FWD
-
Maintenance & Repair
Blower was making a sequelling noise then just stopped working. Wondering if it could be a belt or the motor and the cost it should be.
2005 Chevrolet Impala FWD
-
Maintenance & Repair
In my '02 impala i just noticed on my Blower speed switch the #1 setting is not working but the 2-5 is. I looked in the manual to see if there is a low speed fuse but I didn't see anything. Any Ideas...
2002 Chevrolet Impala
-
Maintenance & Repair
Blower not working, it is only getting 3-vdc, replaced the Blower resistor twice both new resistors only supply 3-vdc to blower on setting 1 to 4, no voltage at all on high setting 5. I removed the da...
2001 Chevrolet Impala
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.