Guru9L8DHM answered 3 years ago
THE BATTERY CABLE EITHER ONE,...WITH KEY IN IGN AFTER BATTERY CABLE HAS BEEN OFF FOR 30 MINUTES ATTACH BATTERY CABLE, SIT IN DRIVERS SEAT AND NO IGNITION ON, DEPRESS THE ACCELERATOR 3 TIMES SLOWLY, PULL KEY OUT OF IGNITION AND INSERT KEY AND THEN START YOUR CAR, CAUSE YOU JUST RESET THE ECM/ECU I JST WENT THRU THE SAME PROBLEM
Code p0340 replaced camshaft position sensor. Went to clear code, but same code popped up. I checked wire and it’s fine what can I do next thanks. Car miles 255,000
2000 Toyota Camry LE
-
Maintenance & Repair
Hi, I have a V4 1996 Camry that had a rapid, loud clicking noise (seems to be by the timing belt and engine) when idle and it mostly went away while accelerating. Check engine light came on about a ...
1996 Toyota Camry
-
Maintenance & Repair
what are all hose's i can change to my Camry 2000- without jacking, kind of proactive effort.
2000 Toyota Camry LE
-
Maintenance & Repair
Hello! My 2005 Toyota Camry is majorly stalling when I put the car in drive. My husband and I were on our way home and were caught in a major thunderstorm that flooded most of the roads in our are...
2005 Toyota Camry
-
Maintenance & Repair
2018 Toyota Camry: Just recently the service engine light came on. Took it to Auto Zone to run a free check. Got a code for the water pump. No water leaking, no overheating, not sure why this code w...
2018 Toyota Camry LE
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.