I have an 01 s10 manual that i cant get out of neutral, when i try an push the shifter into gear it makes a nasty sound. is this a transmission issue or a master cylinder problem, my clutch sinks all the way too the floor there is no leverage in the pedal? any help would be appreciated.

Asked by Ryan_Ibsen Jan 28, 2016 at 02:54 PM about the 2001 Chevrolet S-10 RWD

Question type: Maintenance & Repair

Manual s10 2001 won't come out of neutral. Clutch pedal sinks all the way to the
floor with no leverage. Curious to know if anyone could tell me a solution?

F_O_R answered 8 years ago

I suspect there is a problem with either the clutch slave or master cylinder. Have you checked to see if there is fluid in the master cylinder?

1 people found this helpful.

Mark helpful

144,885

T_S_T answered 8 years ago

Check your clutch fluid level to make sure it has fluid,if not that may be the issue,or your clutch master cylinder and or clutch is bad.

Mark helpful

Ryan_Ibsen answered 8 years ago

Ok I hope it's just the master cylinder. I appreciate the help, I haven't had time yet to check the fluid but I will. Thank you guys-

1 people found this helpful.

Mark helpful

Your Answer:

I have an 01 s10 manual that i cant get out of neutral, when i try an push the shifter into gear it makes a nasty sound. is this a transmission issue or a master cylinder problem, my clutch sinks all the way too the floor there is no leverage in the pedal? any help would be appreciated. 3 Answers

Manual s10 2001 won't come out of neutral. Clutch pedal sinks all the way to the floor with no leverage. Curious to know if anyone could tell me a solution?

2001 Chevrolet S-10 RWD

-

Maintenance & Repair
I have a 1995 S10LS V6TBI engine in it. I am having a problem with the air conditioner blower motor. When you turn it on. it may or may not work and blow air for you. You can feel the cold air at the vent. but no blower to get it into the cab. I have already replaced the blower switch and it didn't help. Now I am stuck between the relay, the resistor or the motor itself trying to go out. Any help would be greatly appreciated. 1 Answer

1995 Chevy S10LS V6 TBI Engine Problem with a/c blower motor not working all the time Replaced blower motor switch and it still cuts in and out when it wants to Would the relay or the resistor cause t...

1995 Chevrolet S-10 LS LB RWD

-

Maintenance & Repair
Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from under the truck.I looked around and couldn't see anything visibly wrong.I started it up again just fine and started rolling in 1st gear, then I tried to shift to 2nd the truck just stopped and wouldn't go into any gear.At this point the truck will start but when I let the clutch out, it dies(in neutral). Had to remove my drive shaft to be towed on towrope because it wouldn't roll smooth in neutral. When the engine is running now I don't feel any vibration through the gearshift anymore like how I used to before it broke down. What could it be? 3 Answers

Was rolling in 5th gear going 60, heard aloud screeching noise and it threw us forward in the seat and slowed it immediately to about 40.I pulled off to the side of the road and smoke was coming from...

1991 Chevrolet S-10 RWD

-

Maintenance & Repair
I have a 98 s10 2.2l with a nv1500 there is a load squealing coming from the trans when I shift into first and attempt too take off I've replaced the trans the slave the master the clutch the pilot 2 Answers

Please help I can't figure it out I've changed everything associated with the trans and it's still there

1998 Chevrolet S-10 LS LB RWD

-

Maintenance & Repair
my 1989 chevy s10 jumps really bad when i get to a surtin part in the throttle idk what it is need help 4 Answers

my 1989 chevy s10 has a 2.5l throttle body engine jumps really bad when you get to one spot on the throttle evry thing else is good runs good only that one spot in jumps around really bad linke its ...

1989 Chevrolet S-10 LB RWD

-

Maintenance & Repair

Looking for a Used S-10 in your area?

CarGurus has 2 nationwide S-10 listings starting at $12,975.

Used Chevrolet Silverado 1500

222 Great Deals out of 5,872 listings starting at $2,975

Used Ford Ranger

21 Great Deals out of 1,606 listings starting at $3,995

Used Toyota Tacoma

45 Great Deals out of 1,079 listings starting at $9,399

Used GMC Sonoma

1 listing

Used Nissan Frontier

22 Great Deals out of 854 listings starting at $6,000

Used Ford F-150

320 Great Deals out of 13,991 listings starting at $1,712

Used GMC Sierra 1500

132 Great Deals out of 6,515 listings starting at $3,975

Used Dodge Dakota

15 listings starting at $5,888

Used Chevrolet Corvette

22 Great Deals out of 1,084 listings starting at $15,000

Used Chevrolet Silverado 2500HD

28 Great Deals out of 1,243 listings starting at $9,500

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

I have an 01 s10 manual that i cant get out of neutral, when i try an push the shifter into gear it makes a nasty sound. is this a transmission issue or a master cylinder problem, my clutch sinks all the way too the floor there is no leverage in the pedal? any help would be appreciated.

3 Answers

Your Answer:

Looking for a Used S-10 in your area?

Shortcuts

Search Chevrolet S-10 Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

I have an 01 s10 manual that i cant get out of neutral, when i try an push the shifter into gear it makes a nasty sound. is this a transmission issue or a master cylinder problem, my clutch sinks all the way too the floor there is no leverage in the pedal? any help would be appreciated.

3 Answers

Your Answer:

Related Questions