I have a 96 dodge 5.9 4x4. When put into reverse it either drops to 300rpm or it dies. OD won't go in
Replaced tps, cleaned, IAC sensor. OD was
working then it wuit, then it worked again,
now it won't at all.
Asked by Ledgerwood7 Jun 09, 2015 at 10:16 PM about the 1996 Dodge RAM 1500 Laramie SLT Club Cab 4WD
Question type: Maintenance & Repair
Replaced tps, cleaned, IAC sensor. OD was
working then it wuit, then it worked again,
now it won't at all.
Replaced tps, cleaned, IAC sensor. OD was working then it wuit, then it worked again, now it won't at all.
1996 Dodge RAM 1500 Laramie SLT Club Cab 4WD
-
Maintenance & Repair
I know the truck recently had a newer motor put in from a 1998 dodge ram. I have already changed the fluid and filter and checked the fluid level when it was warm checked the level twice it was goo...
1997 Dodge RAM 1500 Laramie SLT Club Cab LB 4WD
-
Maintenance & Repair
reverse issues
1995 Dodge RAM 1500 LT LB RWD
-
Maintenance & Repair
not completely the engine just dies, i coded it and it said the o2 sensor was bad, so i replaced that, just as soon as i replaced that my gas tank started to leak. I dont know if it was leaking when...
1997 Dodge RAM 1500 Laramie SLT Club Cab LB RWD
-
Maintenance & Repair
Hello all just ask the same question over again but here we go. I have a 2001 1500 5.9 4x4. The truck starts runs but will not engage into any gear. The transmission was just rebuilt and worked f...
2001 Dodge RAM 1500 SLT Quad Cab LB 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.