firebird338 answered 9 years ago
If you did not get the filter seated in correctly the pump is not going to pump properly. Did you remove the old gasket from to old filter before installing new filter and gasket sometimes it stays on transmission when removed and has to be pryed off before installing the new filter and gasket. Will not get good seal if old gasket was not removed.
Drove truck when it was one and a half quart low of transmission fluid truck got where it would not shift added fluid now it's better but slow to shift out of first
1998 Dodge RAM 1500 Laramie SLT 4WD
-
Maintenance & Repair
after changing the transmission oil filter and oil I start hearing a roaring sound and the transmission doesn't excelared good
2003 Dodge RAM 1500 SLT Quad Cab LB RWD
-
Maintenance & Repair
I just swapped engines from a 96 dodge ram 1500 with the 5.9 to a 99 dodge ram 1500 also with a 5.9. Engine is running good but the transmission won't shift into gear. I dumped about 3.5 quarts of t...
1999 Dodge RAM 1500
-
Maintenance & Repair
Transmission is randomly kicking completely out of gear Through all speeds and all gears. Transmission has 10,000 Miles on it And is a remanufactured transmission from DodgeI I am regretting Buy...
1996 Dodge RAM 1500 Laramie SLT Club Cab 4WD
-
Maintenance & Repair
1998 1/2 ton Dodge Ram (Auto) At times, when starting to move, rpm needle runs high, tapping the gas peddle will bring it back down, Is this a solinoid prob / pressure sensor problem ?
1998 Dodge RAM 1500 ST Club Cab LB 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.