check engine light on
I replaced the mass flow sensor and a map sensor and reset
it it but the OBD2 reader but the check engine light still on?
Asked by Shaun Decastro Dec 06, 2020 at 10:37 PM about the 2006 Volkswagen Jetta 2.5L
Question type: Maintenance & Repair
I replaced the mass flow sensor and a map sensor and reset
it it but the OBD2 reader but the check engine light still on?
I replaced the mass flow sensor and a map sensor and reset it it but the OBD2 reader but the check engine light still on?
2006 Volkswagen Jetta 2.5L
-
Maintenance & Repair
So my husband was about to park in the driveway and the check engine light turned on and the car turned off and the check engine light turned on. After a few attempts the car started and the light...
1999 Volkswagen Jetta New GLS
-
Maintenance & Repair
1997 GLS has "Check Engine" light on, speedometer, gas guage all going haywire. Took it to the shop and they said it needed a new sound board at the cost of around $1,000 for repair and part. Will t...
1997 Volkswagen Jetta GLS
-
Maintenance & Repair
This a.m. for the 1st time my check engine light came on & immediately afterwards the EPC light came on & engine started shaking so I shut engine off & re started & EPC light never came back on & ...
2018 Volkswagen Jetta 1.4T S FWD
-
Maintenance & Repair
My check engine light is on in my 02 vw jetta 1.8t it runs fine but everytime I put gas in it doesn't want to start... doesn't matter if I put $5 or if I fill it up... Any suggestions?
2002 Volkswagen Jetta GLS 1.8T
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.