1999 tahoe 4 wheel drive
Asked by BowTieTiliDie2231 Apr 12, 2020 at 04:48 PM about the 1999 Chevrolet Tahoe LT 4-Door 4WD
Question type: General
When I put my tahoe in 4 hi the front dont get
tra tion but front drive shaft seems to be in
4Wheel Drive and if I go to put it in 4 lo the
light blinks and loud clunk noise and few
seconds later loud clunk noise then it goes
back to 4 hi but still no front traction
6 Answers
Try to put in lo 4x4 moving only at 20 mph should work then. Good Luck!
BowTieTiliDie2231 answered 4 years ago
The light will only blink when putting in yo four low until I put it in neutral
Try working this several times after you back up and go forward slowly. You can try it stopped or moving. I would try both many times. 4 Low should only be engaged when you are stopped in neutral.
BowTieTiliDie2231 answered 4 years ago
I have done everything that has been suggested. I have put a new actuator and changed all fluids checked fuse. I get in crank truck put it in N then I press 4 high the light comes on and stays on but it's still back tires only spin. Put in N and press 4 Low and it clunks pretty good and the button will be flashing then you will here the clunk again and then goes to 4 high and light stays on but even in 4High just back tires spin.
