This could be a defective part. It could also be caused by acid rain, excessive heat, fluid stains, gasoline droplets, or contaminated fingerprints.
some dork might have put on that tire shit.....it recks your tires and molding!!! you have to buy the tire dressing that is water based...not oil...meguire's is the best!
I have spoting on the black door moldings- is this an issue with a defective part? Have had vehicle for less than a week and have NOT been through a car wash yet
2007 Jeep Commander Sport 4WD
-
Maintenance & Repair
My passenger rear directional stops working shortly after start-up, rear driver's taillight goes out and front driver's amber light comes on when applying brake. Is this a relay issue or something el...
2007 Jeep Commander Limited
-
Maintenance & Repair
I have a 06 Jeep Commander. My car sat for a few days with a flat tire. I finally had time to deal with it. When I aired up the tire and turned the car on to get to a repair shop my hazard lights...
2006 Jeep Commander Limited 4WD
-
Maintenance & Repair
This problem is very scary I feel like I cant drive long distances more than 30 miles without the heat problem. Could this be a fire hazard?
2008 Jeep Commander
-
Maintenance & Repair
I need to know how to get my 2006 Jeep commandeer out of limp mode. P0700 which is just a generic code saying there is a tcm fault code. And p2706 which is saying dead circuit to multi solenoid switch...
2006 Jeep Commander Limited 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.