#10 is for the starter and it’s low amperage so there must be a feedback in the crank circuit, could be a bad ignition switch, anti thief module, gear selector switch or wiring. Begin at the starter itself and look for burnt, cross connected or rubbed through wiring. These things are a bear when it comes to wire tracing.
Any answers
2007 Chrysler 300 Touring RWD
-
Maintenance & Repair
My Chrysler 300 with the 3.5 engine stalled out and wont start up right since. It starts for a second and runs for a second and starves for fuel. I replaced the fuel pump assembly and it still wont ...
2007 Chrysler 300 Touring RWD
-
Maintenance & Repair
My A/C is blowing out hot air, can someone tell me what it could be?! We checked the Freon and it is fine but worried it may be my compressor.
2006 Chrysler 300 Touring RWD
-
Maintenance & Repair
My 2007 Chrysler 300 makes a humming noise when engine gets up to 30 miles my engine light is on also do any one know what that could be.
2007 Chrysler 300 Touring RWD
-
Maintenance & Repair
CAR WILL NOT CRANK OR START AT ALL .
2007 Chrysler 300 Touring RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.