how to bypass immobilizer?
Asked by Booman0800 May 26, 2021 at 09:04 AM about the 2007 Dodge Magnum SE RWD
Question type: Maintenance & Repair
how can i bypass immobilizer after changing ignition switch and car still wont
start?
Asked by Booman0800 May 26, 2021 at 09:04 AM about the 2007 Dodge Magnum SE RWD
Question type: Maintenance & Repair
how can i bypass immobilizer after changing ignition switch and car still wont
start?
how can i bypass immobilizer after changing ignition switch and car still wont start?
2007 Dodge Magnum SE RWD
-
Maintenance & Repair
I bought a 2005 Dodge Magnum 5 months ago, car was running fine no problems up until a few days ago when I got a oil change a leak showed up. I’m not an expertise so I was back and forth taking my ...
2005 Dodge Magnum
-
Maintenance & Repair
Im replacing the belt moulding/window sill on my magnum and need to know how to remove them
2005 Dodge Magnum SXT AWD
-
Maintenance & Repair
I don't drive it much. When I went to start it, battery was dead. I charged it enough to start it and when it did It revved up really high it idled down slowly, when I gave it gas it revved up again...
2006 Dodge Magnum SRT8 RWD
-
Maintenance & Repair
My car sat for about three weeks and when I got the chance to finally start it the check engine light was on and the car would NOT shift out of low; luckily I found two bad fuses in the rear fuse box;...
2005 Dodge Magnum R/T RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.