No cruise vontrol
Cruise control quit
working. No indication on
dash cluster or control
level. Could this be
caused by a fault code for
EGR sensor I need to
replace? Code P0406.
Asked by Jerichobrady Sep 25, 2016 at 01:00 AM about the 2007 Dodge Magnum SXT RWD
Question type: Maintenance & Repair
Cruise control quit
working. No indication on
dash cluster or control
level. Could this be
caused by a fault code for
EGR sensor I need to
replace? Code P0406.
enginecreator answered 8 years ago
I do not think it would be connected, But dodge does interconnect various circuits.
Cruise control quit working. No indication on dash cluster or control level. Could this be caused by a fault code for EGR sensor I need to replace? Code P0406.
2007 Dodge Magnum SXT RWD
-
Maintenance & Repair
My car sat for about three weeks and when I got the chance to finally start it the check engine light was on and the car would NOT shift out of low; luckily I found two bad fuses in the rear fuse box;...
2005 Dodge Magnum R/T RWD
-
Maintenance & Repair
I start my car and the swerve indicator warning comes on and stays on. This forces the engine down to 35 mph. It does this for no reason from a dead start.
2007 Dodge Magnum
-
Maintenance & Repair
It will occasionally start...no warning lights are on
2007 Dodge Magnum SXT RWD
-
Maintenance & Repair
I have a 2006 Dodge Magnum. I've replaced the tstat, flushed the heater core and the hoses, replaced the water pump and the blend door accuator, the cars heat hardly blows hot unless I'm moving fa...
2006 Dodge Magnum SXT RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.