Car turns over but wont start, changed fuel filter now it starts for a few seconds then stops
Asked by Ashley Apr 13, 2014 at 10:09 PM about the 2002 Buick LeSabre Custom Sedan FWD
Question type: Maintenance & Repair
Car wont start, it turns over but wont start.
Changed the fuel filter today and after we
changed it it seemed to stay started for a
few seconds but then would stop. The
battery is new, the fuel pump works, the
spark plugs all produce sparks. And ideas?
Please I could really use some help.
17 Answers
Is check engine light on? If so need to get codes. Auto zone will do this for free. Then post codes back on here. Could be any number of things. Check fuel pressure at fuel rail. This will insure that fuel pump is putting out enough pressure. Could also be dirty/faulty idle air control valve or throttle plate, stuck open pcv valve, stuck open egr valve or possibly a vacuum leak.
a security shutdown can occur , check for security light blinking if equipped with
If the security shutdown occurs how do you fix that
If your security light blinking how do I start my car it won't start
I have a 2002 Buick LeSabre 3.8 engine fwd I had to get a junk yard transmission because mine blew a hole on the passenger side where the cv axle goes in and now that the junk yard transmission is in now it wont start wont do anything just click's at the fuses box under the hood. jump start it cranks, sometimes the dash lights come on and some times they don't, It's never done this before so I'm not sure whats going on. I NEED HELP PLEASE also checked all ground wires and everythings tight and the security light is not on and not flashing so I'm just so lost right now.
check to make sure your ac compressor is turning as I had the same experience with car turning over but not starting. turns out ac compressor was not turning, had no money for new compressor so I got a pulley bypass and once i put that in it worked. as soon as i popped the serpentine belt off initially it cranked right up, but obviously don't want to run it without that piece on.
I have a 1991 Buicklesabra new fuel pump new filter want start not getting gas
I put a new map sensor on my 2000 Buick lasabell custom it start cranking goof but after a hour when I try to crank it bk it turn all the way over bot 5 times before it crank up what could be the problem
I'm a 2004 Buick LeSabre the car act like they want to start up but it won't I don't know what is wrong with it I thought I ran out of gas but I tried putting gas in there and it still won't start acting like it wants to start but can you please help me
I have a 2000 Buick LeSabre car will not crank up and I put gas in and still won't crank what could be the problem
I'm a 2004 Buick LeSabre the car act like they want to start up but it won't I don't know what is wrong with it I thought I ran out of gas but I tried putting gas in there and it still won't start acting like it wants to start but can you please help me
There is a bus connector under the trim on the driver side door mine was corroded wiggled it car starts every time
I got a 2001 Buick LeSabre it turn over but it won't crank I took the car pack off and Clint the Mazza and it still won't crank I need help
my buick 02 lesabre i change ignition coil module. fule filter. spark plugs and cables and still crank but don’t stars any help please
Check the cam sensor, as it controls injector pulse
02 buick lesabre turnsover but wont start chaned crank cam plugwires advance code is u 10 16 witch they say its a wire not to the computer what could it be