Bad computer could this be the problem
1 Answer
beatupchevy answered about a year ago
Look for a good motor to chassis ground , a braided wire is best , Some dielectric grease goes on the metal plate of the module . Your experience may differ
beatupchevy answered about a year ago
Look for a good motor to chassis ground , a braided wire is best , Some dielectric grease goes on the metal plate of the module . Your experience may differ
My 04buick keeps burning up ignition module why shows no codes
2004 Buick LeSabre Custom Sedan FWD
-
Maintenance & Repair
Ok. I have this buick with so many problems it seems. Recently the check engine light has been on. I had the catalytic converter taken off and just had a straight pipe ran, i changed the egr valve, ...
1990 Buick LeSabre Custom Sedan FWD
-
Maintenance & Repair
2005 Buick LeSabre, 68,129 miles, 2nd owner of the car, regular maintenence has been kept on car, checked oil and filter when happened and less than 1\4 cup of oil in filter.
2005 Buick LeSabre Custom Sedan FWD
-
Maintenance & Repair
This is only while driving, does not happen when parked and idling or even if idling in gear.
2004 Buick LeSabre Custom Sedan FWD
-
Maintenance & Repair
Car was running fine going down the road all of a sudden it started sputtering real bad so far I have replaced plugs,wires,o2 sensor, crankshaft sensor, fuel filter , coils and module, still sputter...
2003 Buick LeSabre Custom Sedan FWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.