1991 Chevy 2500 4x4 cold starts up runs fine, shut off won't restart till it sits to cool. longer run time, longer it takes to restart 10 minutes-1 hour?

Asked by Fiero_495 Mar 27, 2015 at 02:52 AM about the 1991 Chevrolet C/K 2500 Silverado Extended Cab RWD

Question type: Maintenance & Repair

go out in morning starts right up, if I turn it off immediately or drive it 10 -15 miles and turn it off doesn't matter it won't restart till it sits around ten minutes. it will turn over, but not start, if I spritz a little starting fluid it will fire and die and or "diesel" and die but wont stay running until it sits and then will start up without any assistance as long as it has sat to cool?

30,540

mikeatpriestlake answered 9 years ago

Have the injectors tested.

1 people found this helpful.

Mark helpful

Fiero_495 answered 9 years ago

The injectors are functioning, new coil was put in (no change), timing was 3 degrees fast but within parameters according to the smog guy ( it passed California smog test by the way).

Mark helpful

Your Answer:

1991 Chevy 2500 4x4 cold starts up runs fine, shut off won't restart till it sits to cool. longer run time, longer it takes to restart 10 minutes-1 hour? 2 Answers

go out in morning starts right up, if I turn it off immediately or drive it 10 -15 miles and turn it off doesn't matter it won't restart till it sits around ten minutes. it will turn over, but not sta...

1991 Chevrolet C/K 2500 Silverado Extended Cab RWD

-

Maintenance & Repair
My truck runs at around 160-170, and it takes incredibly long to heat up. Is something wrong? 3 Answers

I have no idea if I have an aftermarket thermostat or not, and it takes quite a while to get heat. Is this normal? Any suggestions are greatly appreciated

1990 Chevrolet C/K 2500 Silverado LB 4WD

-

Maintenance & Repair
Tell me how to fix my truck. 11 Answers

I have a 1995 chevy truck it's a 2500 7.4 454. It flashed codes 32 and 36 I have replaced egr, throttle positioning unite, O2 sensor, map sensor, temp sensor, ignition coil, distributor cap and rotor....

1995 Chevrolet C/K 2500 Cheyenne Extended Cab LB HD 4WD

-

Maintenance & Repair
We have a 1993 Chev 2500 4x4 5.7L, we changed out the wiring harness, now changed the whole distributor, cap and rotor, put motor to TDC and it still not start. It will turn over but not start. 1 Answer

changed wiring harness, distributor, rotor and cap it will turn over but not start. With the spark plug wires, where do you consider #1 on the distributor?

1993 Chevrolet C/K 2500

-

Maintenance & Repair
Engine hard to start, runs rough then engine light on after 10 minutes or when warm then idle picks up... 4 Answers

Hello, I I have a 1993 k2500 4x4 5.7 liters that I bought new. 3 weeks ago driving it, the engine lite came on (never done this before) but it drove just fine. Next day when I started it , the engi...

1993 Chevrolet C/K 2500 Silverado Extended Cab LB RWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.