Read the trouble codes. Maybe you did not get everything. You can also clear the codes and see what reappears.
Thanks for the reply once I changed the the flow sensor changed the mechanic told me it was a misfire in cylinder 3 It was flashing once i changed it the light stopped blinking but it stayed now wen it drives the gears so like they are havin trouble shifting
I changed my airflow sensor and my 3rd cylinder ignition coil on my 2007 Lincoln Mkz and the engine light is still on
2007 Lincoln MKZ AWD
-
Maintenance & Repair
I was looking at a 2008 Lincoln MKZ off Craigslist. 93,000 miles, no check engine light on but the wrench light is on. I think the wrench light is an indicator for the AWD/Transmission system? It dr...
2008 Lincoln MKZ AWD
-
Maintenance & Repair
When I turn off the car the motor continues to run for a few seconds after the car has been turned off and it sounds like it's slowing down like the motor is still spinning. And the idle seems off ...
2007 Lincoln MKZ
-
Maintenance & Repair
Sometimes it resembles a vibrating sound. Service tech could not duplicate the noise. I have owned the car for 2 months and it has 32,000 miles on it. Any ideas?
2007 Lincoln MKZ FWD
-
Maintenance & Repair
When travelling at 120km after about 40km AWD message comes up- AWD disabled, then stays like that for a few km then cycles back on.
2014 Lincoln MKZ AWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.