Engine knock
Can I replace rod bearings in my 2003 ford explorer
engine.without removing engine?
Can I replace rod bearings in my 2003 ford explorer engine.without removing engine?
2003 Ford Explorer XLT V6 4WD
-
Maintenance & Repair
80000 miles. engine ran good 6 months ago. Upon startup a knock developed. Changed oil, no change. Replaced tensioners on both front and rear, old ones looked good, but replaced anyway. No change...
2003 Ford Explorer
-
Maintenance & Repair
When engine is cold then started it ticks/knocks for 30 sec to 2 mins the oil has been changed every 5k miles with 5w30 sounds like it might be coming from the front driver side valve cover but ca...
2004 Ford Explorer XLT V6 4WD
-
Maintenance & Repair
working on a 06 ford taraus 3.0 single ohv engine motor has a intermittent knock in the motor only noticeable at idle i put and stethscope on it its internal noise sounds like a wrist pin or main bea...
2006 Ford Taurus SEL
-
Maintenance & Repair
Aight I cleaned up my festivas Carb and now the engine will start and idle relyably. Next problem is is there is a loud tapping/knocking sound coming from I THINK the third piston from the left O O X...
1988 Ford Festiva
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.