Hornet_2497 answered 6 years ago
I've noted that most oil pressure sending units are located pretty close to the oil filter base. That's because oil pressure is measured as it comes off the pump, going to the filter. There might be a YouTube video you can see if you are not sure where to look.
It’s on the Back of the engine block . You access it from drivers side over the top of engine near firewall.
Yesterday oil pressure went to 80. My husband changed the oil now pressure is at zero. Could this be the sending unit?
2005 Chevrolet Tahoe
-
Maintenance & Repair
Where is the oil pressure sending unit on a 2005 Chevy Tahoe 5.3l vortec 4wd
2005 Chevrolet Tahoe LS 4WD
-
Maintenance & Repair
It has happened twice in year. Oil pressure light comes on, check oil and there is none. Nothing leaking on the drive below the car. Happend both time after sitting for a couple of days. Add 5 to ...
2009 Chevrolet Tahoe 2LT RWD
-
Maintenance & Repair
I have an 08 tahoe that I would like to know whats causing the oil pressure to be low. When the truck is parked and not running the oil pressure gauge stays at 20. I drive it for about 15 minute...
2008 Chevrolet Tahoe LT 4WD
-
Maintenance & Repair
05 chevy tahoe 5.3l v8. I bought the car it was fine. Started getting low oil pressure. Then it started ticking. Since it had over 300000 miles on it we decided to do a engine swap. Got the new eng...
2005 Chevrolet Tahoe LS 4WD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.