2008 altima 2.5s no power and engine wont rev
Asked by Kacy Jun 23, 2015 at 09:38 PM about the 2008 Nissan Altima 2.5 S
Question type: Maintenance & Repair
I was on my way from Kentucky to ohio last night and my car started to loose power its a 2008 altima 2.5s and when I pulled over to side of road I shut it off for about a minute than started it back up while in park I pushed the gas to rev it up a little and it just stayed and idling speed. rpms didn't move and no sound from engine of it reving up. Than after deciding to cancel trip so we don't get stranded to far from home we turn around and 20 minutes later the car acts fine as if nothing ever was wrong. Please help
6 Answers
Could be the TCM (transmission control module) or a CPS (cam position sensor) or the throttle body. The newer vehicles have a electrically controlled butterfly instead of the old cable version. These are known to go bad and you will have intermittent power. I would start with the cam sensor. It's cheaper than the TCM or throttle body. If your check engine light is on, get the codes read.
there is no check engine light on our any other alerts that read on the display gauge in the dash.
Paul_amber answered 9 years ago
My 2008 Nissan Altima is doing the same thing I've been doing research on it and just about everything is coming back to the ECM Nissan said I needed a new transmission so had one put in now back to the same thing after 6 months in going to try the ECM on mine
mrsbossjds answered 6 years ago
So i have 08 Nissan altima 3.5 V6 and car will not accelerate or go over 20 MPH starts up gears and everything work I'm not sure if its the catalytic converter or the alternator decoupler pulley
My nissan Altima accelerate but will not rev up at all
Guru9WN3D1 answered 3 years ago
I have a2008 Altima wouldn’t accelerate found out the hose that goes from breather to throttle body had a crack in it replaced it and it runs fine
