control for canister close valve
30

Asked by ktr52 May 11, 2014 at 10:35 AM about the 2008 Hyundai Santa Fe 3.3L SE FWD

Question type: Maintenance & Repair

I was getting a code 455 meaning gross leak in emissions, traced it down to the canister
close valve not closing. The valve works when jumper ed to 12 volts and ohm's out good at
20.6 ohms. There is 14 volts to the valve when its disconnected but as soon as I connect
the valve it goes to 0 volts. Where does the voltage drive for the valve come from?

3 Answers
30

ktr52 answered 10 years ago

Jim Thanks for your response but with the valve disconnected there is 14 volts to the connector for the close valve yet when I reconnect it it fail to pick the valve. Yet the close valve works fine when I jumper 12 volts to it and it Ohms out good. I can pull a good vacuum on the canister and gas tank. I think the problem is the drive to the close valve won't energize the valve.

3 people found this helpful.
Mark helpful
20

GuruHRRNW answered 5 years ago

Bad control relay. Relay can't carry enough current to drive the valve solenoid. Hope the fix didn't cost him too much.

2 people found this helpful.
Mark helpful

Your Answer:

Related Questions

  • control for canister close valve 3 Answers

    I was getting a code 455 meaning gross leak in emissions, traced it down to the canister close valve not closing. The valve works when jumper ed to 12 volts and ohm's out good at 20.6 ohms. There is...

    2008 Hyundai Santa Fe 3.3L SE FWD

    -

    Maintenance & Repair

  • Purge control valve(s) 2 Answers

    How many purge control valve(s) does a 2009 Hyundai Santa Fe have? Replaced the one under the hood but the check engine came on again.

    2009 Hyundai Santa Fe 2.7L GLS FWD

    -

    Maintenance & Repair

  • Cruise Control won't disengage! 1 Answer

    I didn't turn on nor have I used cruise control in months but when I started the car today the rpm went from 1 to 3 without touching gas. Then the car took off like cruise control was engaged but it w...

    2002 Hyundai Santa Fe 2.7L GLS FWD

    -

    Maintenance & Repair

  • where is the purge valve #pv713 located around the gas tank 2 Answers

    bad valve

    2007 Hyundai Santa Fe

    -

    Maintenance & Repair

  • Hyundai Santa Fe valve cover gasket replaced, now AC not working. 1 Answer

    Recently had both valve cover gaskets replaced. Now AC not working. Could they be related? When turning on AC, button light comes on, but I do not feel the AC pull power or "tug" on the engine. Th...

    2001 Hyundai Santa Fe 2.7L LX FWD

    -

    Maintenance & Repair

Santa Fe

Looking for a Used Santa Fe in your area?

CarGurus has 1,639 nationwide Santa Fe listings starting at $3,950.

Postal Code:

Shortcuts

Search Hyundai Santa Fe Questions

CarGurus Experts

  • #1
    me29
    Reputation
    6,550
  • #2
    JP1956
    Reputation
    2,870
  • #3
    SubaruTech5862
    Reputation
    2,030
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Hyundai Tucson
92 Great Deals out of 2,363 listings starting at $4,895
Used Kia Sorento
76 Great Deals out of 2,450 listings starting at $4,495
Used Honda CR-V
85 Great Deals out of 4,517 listings starting at $440
Used Toyota Highlander
28 Great Deals out of 761 listings starting at $6,950
Used Toyota RAV4
109 Great Deals out of 2,713 listings starting at $2,500
Used Honda Pilot
31 Great Deals out of 1,304 listings starting at $2,995
Used Hyundai Sonata
44 Great Deals out of 1,078 listings starting at $2,495
Used Kia Sportage
42 Great Deals out of 1,929 listings starting at $1,054
Used Nissan Rogue
147 Great Deals out of 5,466 listings starting at $2,200

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.