Have tie ECU scanned for codes at a local autoparts store. Post the codes here. This is usually a free service.
Fabulous1970 answered 5 years ago
I have a 2011 Chevy Malibu and my car drags and makes a horrible sounds when it’s on 2 rpms. Like a rambling sound. I have to press the gas hard and it goes crazy on the rpms. Does anyone know what this can be?
I Changed My MAF & MAP Sensors But My Car Is Still Riding Rough & Hesitant During Acceleration
2010 Chevrolet Malibu LS FWD
-
Maintenance & Repair
My car keeps cutting off during daylight hours constantly while running but it starts right back up every time. No bogging of any kind it just shuts off.After dark it runs like its BRAND NEW....Wha...
2006 Chevrolet Malibu V6 LT FWD
-
Maintenance & Repair
OK so i have a 2005 chevy malibu and when I start the car and put in gear it is fine after driving for a little bit I'll lose acceleration and it won't accelerate but the engine is revving. The...
2005 Chevrolet Malibu
-
Maintenance & Repair
My 2011 malibu is making this clicking sound when I'm driving and going over bumps could that be my struts
2011 Chevrolet Malibu LS FWD
-
Maintenance & Repair
I have a Chevrolet Malibu of 2013 , I took it to a mechanic too get my upper and lower radiator hoses replace and I picked up my car once it was ready after I was driving it over an 1hour my car w...
2013 Chevrolet Malibu 1LT FWD
-
Maintenance & Repair
CarGurus has 1,133 nationwide Malibu listings starting at $1,295.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.