Asked by Leonard Oct 14, 2018 at 07:52 AM about the 2010 Nissan Armada Platinum
Question type: Maintenance & Repair
I have a 2010 Nissan Armada, when I turn on the heat it blows cold, or luke warm air. I also hear a clicking noise for about 30 to 45 seconds after I stat it up. What cause my heat not to work, and the clicking noise?
The clicking noise is a bad blend door actuator, follow the noise, most actuators are easy to change if you can get to them.
Not in the 2010 Nissan Armada! The dash has to be removed to replace the actuators. This job costs between $1500 and $1800 depending on the dealership you have do the work.
I have a 2010 Nissan Armada, when I turn on the heat it blows cold, or luke warm air. I also hear a clicking noise for about 30 to 45 seconds after I stat it up. What cause my heat not to work, and ...
2010 Nissan Armada Platinum
-
Maintenance & Repair
2006 Nissan Armada SE
-
Maintenance & Repair
I have replaced the blower motor assembly, variable blower controller module, and relay. Any ideas? It's cold outside!! Lol! At first it went from normal to blowing only on high for both the heater an...
2007 Nissan Armada SE 4WD
-
Maintenance & Repair
I have a 2010 Nissan armada the heat only works on the driver side but will not work on the passenger side or in the back. Need solutions to problems
2010 Nissan Armada Platinum 4WD
-
Maintenance & Repair
I recently changed the starter and the intake manifold gaskets on my Nissan and now it will turn over but will not start what could be the problem
2007 Nissan Armada
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.