2010 t&c, no gas petal after replacing wheel bearing and battery
Asked by Laura May 03, 2017 at 09:40 PM about the 2010 Chrysler Town & Country Touring FWD
Question type: Maintenance & Repair
We replaced the front wheel bearing and
put new battery in 2010 Chrysler town &
country. Went to test drive and get no
response from gas petal. ABS, throttle
body control.... HELP
6 Answers
There is check engine light on dash
It was giving 4 codes... 1. ESP/TCS Indicator Light 2. Malfunction Indicator Light 3. Electronic Throttle Control Light 4. ESP/BAS Indicator Light.
Husband thinks replacing battery may have shorted out throttle body...? Any chance the wheel bearing/speed sensor would cause the gas petal to not respond?
Code ESP/TSC it's for traction control system and this code it's not effects for vehicle throttle. There is code for TP this code for throttle position sensor but my advice there is on gas pedal control for throttle can you check the connector may be it's loss.
Did you find out what it was? This just happened to us
We replaced the electronic throttle control and still had to tow it to dealership to be programmed... not sure why the ETC went bad!