That means that the 4 low has been selected but the shift motor is unable to complete the the command. On my rig it was a bad shift motor, it would do 4 HI but didn’t have the torque to make the 4 LO shift. A new motor and a relearn and it works. But you should have the entire system checked, you could have a underlying transfer case or wiring issue.
My 4 low light recently just started blinking for no reason. What do I need to do?
2010 Dodge RAM 1500 ST Quad Cab 4WD
-
Maintenance & Repair
My dog chewed the harness that controls the 4 wheel drive on my 2014 Ram 1500. Because I am an airccraft electrician, if I can find the tool that will remove the pins from the connector I can repair t...
Dodge RAM 1500
-
Maintenance & Repair
I have a Autobest fuel pump brand new in the box, and was wondering is that all I need to replace my fuel pump or do I need a fuel filter too?
2004 Dodge RAM 1500 SLT Quad Cab LB 4WD
-
Maintenance & Repair
I have a 1998 Dodge ram1500 4x4, i replaced the water pump and fan clutch because it was throwing water at me, changed them, and learned that i had poked hole in my radiator and did not create the w...
1998 Dodge RAM 1500 Laramie SLT 4WD
-
Maintenance & Repair
I swap from a 2005. 4.7 to a 2006 4.7 but I have no fire
2005 Dodge RAM 1500 ST RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.